I-8091

$0.00

2 Axis Stepping / Servo Motor Control Module. I-8091 is phased out and replaced by I-8091W.

Share On:
Categories:	I-8000 Specialty Modules
Review:	Write your review
Resources:	User's Manual Internal I/O PIN Assignment

The I-8091 has officially been phased out and will no longer be available. It has now been replaced by I-8091W.

2-axis steppong/servo motor control card

DN-25 CA2520
DN-25+CA-2520

Parallel I/O Module

2-axis Independent, Simultaneous Stepping Motor Control/Servo Motor Control (Pulse Input Type).

Maximum Pulse Rate: 1 M pps.

Maximum Step Counts: 232 - 1 Steps.

DOS Driver.

Embedded CPU.

Command Type Interface.

2-axis Linear, 2-axis Circular Interpolation.

Automatic Trapezoidal Acceleration/Deceleration.

Output Pulse modes : CW/CCW or Pulse/Direction.

Output Polarity can be Programmable.

2500 Vrms Optical Isolated Signal Output.

3 Optical Isolated Dgital Inputs per Axis for Limit Switches.

Programmable Limit Switch Initial Condition as Normal Open (N.O.) or
Normal Close (N.C.).

Power Consumption: 3.9 W

Your email address will not be published. Required fields are marked *

Overall ratings

Select Rating *

You must be signed in to review! Click here to sign in.