CA-LLD-DC100X-L010

The liquid leak detection cable detects liquid leaks over wide open areas. The liquid leak detection cable can be directly connected to the liquid supply and return lines. It is ideal for use in large surface areas with multiple potential leak points. Has cable break detection and can be connected in series.

When required, communication with the iSN-104 can be programmed based on the Modbus RTU protocol, with the added benefit that different addresses can be configured via hardware to allow for Modbus RTU communication.

• Cable Break Detection: If there is a break in the signal or leak detection cable, the iSN-101/104 knows immediately and triggers an alarm buzzer.
• Supports Multiple Leak Detection Cables: CA-LLD-DC100X-L010 has snap-in connectors at both ends and multiple detection lines can be connected in series to extend the distance.
• Cable Diameter：6mm
• Liquid Leak Detection Cables along with Leader Cable Communicate up to 500 meters
• Carrier：Fluoropolymer
• Sensing wires：2*30 AWG with jacket of conductive fluoropolymer
• Maximum continuous operating temperature：70°C

Applications

iSN-104 is a leakage detection module used in water pipe leak monitoring in buildings and has two working modes:

• Works with water sensing cable installed near the potential leaking pipes or areas to detect leakages and cable breaks with alarm.
• Works with water leakage probe installed in potential leakage areas to detect leaks.