FREE $30.00 Visa Gift Card with CODE: VISA for registered customer's FIRST-TIME purchase.

Cage/NCage Code 3FNF0

Orders ship within a week!

  • Connect with us on LinkedIn Subscribe to our YouTube channel Follow us on Twitter Follow us on Facebook Follow us on Instagram

What is the difference between Server mode and Client mode on the tGW-715i?

The Application Mode setting in the Pair-Connection Settings section determines how the serial port communicates with a remote network Modbus device.

Application mode
Function
Typical example
Server

Supports the normal Modbus TCP/UDP master-to-serial RTU/ASCII slave arrangement. It also acts as the server endpoint when used in a pair-connection.

SCADA software polls a serial Modbus meter over Ethernet.

Client

Initiates communication with a remote Modbus TCP/UDP slave for the reverse-direction application, or connects to a remote gateway configured as a pair-connection server.

A serial RTU master sends requests to a remote TCP slave.

To use Client mode, you normally need to select the network protocol and specify the remote server IP address and TCP port.

In Server mode, those remote-client fields are not used in the same way.

Important Distinction

These settings do not change the serial device into a different physical interface. You must still configure the appropriate serial communication parameters and wire the device correctly.

Troubleshooting Tip: If you are using a normal Ethernet-based Modbus master to poll a serial slave, start with the standard gateway configuration in Question 3. Do not switch to Client mode unless your application requires the serial master-to-network slave or pair-connection arrangement.

Tags
Social Share
    The current post does not belong to any category.
    No categories found
Enable Notifications OK No thanks